Dan-dugan-sound-design E-1 Manual do Utilizador descarregar pdf (Página 17)

Dugan Models E-1 and E-1A User Guide Installation and Configuration

Insert

1. Check the insert jack wiring on your mixing board.

If they are 1/4-in TRS jacks (wired tip = send, ring = return), use TRS-TRS insert ca-

bles to connect the Model E-1A. Other configurations require special cables. The

Model E-1A is wired as follows: tip = input, ring = output.

2. Patch the audio channels in the insert loop (send-return) of each console input strip.

This is the normal way to connect the Model E-1A using a mic-level signal.

Figure 3-3 Analog insert (left) and line level (right) block diagrams

Line Level

Use split insert cables. The receiver output is wired to the tip of the TRS plug. The

console’s line input connector is fed from the TRS plug’s ring.

Digital I/O

1. Move the ANALOG

–

DIGITAL switch to the DIGITAL (down) position.

This switches the input to the DIGITAL IN connectors. Linking is still possible and

the analog outputs remain active.

2. Use two ADAT (Toslink) cables to connect the console’s ADAT interface to the

Model E-1A’s AUD IN and AUD OUT connectors.

Figure 3-4 ADAT audio connectors

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Sem comentários

Dan-dugan-sound-design E-1 Manual do Utilizador Página 17